Brocade Communications Systems FastIron SX 1600, Руководство по настройке, Страница: 145 / 593

Static route next hop resolution
This feature enables the Brocade device to use routes from a specified protocol to resolve a configured static route. By default this is
disabled.
To configure static route next hop resolution with OSPF routes, use the following command.
device(config)# ip route next-hop ospf
Syntax: [no] ip route next-hop [ bgp | ospf | rip ]
NOTE
This command can be independently applied on a per-VRF basis.
This command causes the resolution of static route next hop using routes learned from one of the following protocols:
• bgp - both iBGP and eBGP routes are used to resolve static routes.
• ospf
• rip
NOTE
Connected routes are always used to resolve static routes.
Static route recursive lookup
This feature enables the Brocade device to use static routes to resolve another static route. The recursive static route next hop lookup
level can be configured. By default, this feature is disabled.
To configure static route next hop recursive lookup by other static routes, use the following command.
device(config)# ip route next-hop-recursion 5
Syntax: [no] ip route next-hop-recursion level
The level available specifies the numbers of level of recursion allowed. Acceptable values are 1-10. The default value is 3.
NOTE
This command can be independently applied on a per-VRF basis.
Static route resolve by default route
This feature enables the Brocade device to use the default route (0.0.0.0/0) to resolve a static route. By default, this feature is disabled.
Use the following command to configure static route resolve by default route.
device(config)# ip route next-hop-enable-default
Syntax: [no] ip route next-hop-enable-default
NOTE
This command can be independently applied on a per-VRF basis.
This command works independently with the ip route next-hop-recursion and ip route next-hop commands. If the default route is a
protocol route, that protocol needs to be enabled to resolve static routes using the ip route next-hop command in order for static routes
to resolve by this default route. If the default route itself is a static route, you must configure the ip route next-hop-recursion command
to resolve other static routes by this default route.
Adding a static IP route
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 145