Broan SmartSense SMSC080, Инструкция по эксплуатации

Страница: 5 / 12

MODELS SMSC080 • SMSC110
Page 5
99044621C
Push to
turn ON
Push to
turn OFF
S
mart
S
ense
®
®
SCREWS
SCREWS
HOW TO CHANGE CONTROL COLOR
An almond paddle/frame assembly is included.
1. Use magnetic #1 Philips screwdriver and remove (4) screws
from white paddle/frame.
2. Remove white paddle/frame from control.
Caution: Do not touch or put anything inside control housing;
control damage may result.
3. Place almond paddle/frame on control.
4. Replace (4) screws and lightly tighten them.
Caution: Do not over tighten screws; frame may crack.
RESTORING POWER TO CONTROL
Control stores all settings in nonvolatile memory; so they are not lost
when power is removed. After power loss, control will automatically
return fan to its state (on or off) before power was interrupted.
HOW TO RESTORE CONTROL FACTORY SETTINGS
This “Restore” procedure clears control’s nonvolatile memory. It
returns control to how it was shipped from factory. All Feature
selections are turned off and all links are removed. “Restore”
procedure should be used cautiously; usually it is used only when
first setting up a system or for single unit installations.
Links are unique for each device pair. If one end of the link is
removed, it is important to remove the other end. “Restore” only
removes links within its control. Other link-end needs to be removed
in other device.
CAUTION: Before continuing, choose one of following options: (a)
remove links to target “Restore” control using procedure described
in “How To Remove Specific Individual Links” or (b) “Restore”
all controls in system and “Restore” all other LinkLogic™ and
INSTEON™ devices; then links need to be reestablished using
“How To Link SmartSense
®
System” procedure.
1. Remove power from control’s microcontroller; either: (a)
turn circuit breaker off or (b) pull SET button until it is
fully extended.
2. Wait 15-seconds.
3. Press and hold SET button.
4. For option (1a), turn circuit breaker on while SET button is
pressed. For option (1b), push in and press SET button in
one motion.
5. Continue holding SET button for 3-seconds after power is
applied then release it.
Within 2-seconds, fan and LED turn on; stay on for 1 to
2-seconds and then turn off.
6. If control does not respond as described, start process over
with step 1.
PADDLE / FRAME
ASSEMBLY