Broan BCS3 Series, Инструкции по установке и эксплуатации

Страница: 9 / 14

9
5. INSTALL THE HOOD
WARNING !
Risk of electric shock. Electrical wiring must be done by qualified personnel in
accordance with all applicable codes and standards. Before connecting wires, switch
power off at service panel and lock service disconnecting means to prevent power to be
switched on accidentally.
Connect House Power Cable to range hood
wiring: BLACK to BLACK, WHITE to WHITE and
GREEN or bare wire under GREEN ground screw.
Hang hood from (4) mounting screws
driven part-way into cabinet locations
(shown in illustrations under step 3
PREPARE THE HOOD LOCATION).
Mounting screws are included in parts
bag. Slide hood back towards wall until
mounting screw heads are engaged
in narrow end of keyhole slots in top of
hood. Tighten screws securely. Add 5
th
mounting screw in center hole in hood
and tighten securely.
DUCTED INSTALLATION ONLY:
Connect ductwork to hood and use metal
foil duct tape to make joints secure and
air-tight.
Make sure the damper assembly
(or round duct plate without damper)
enters the ductwork and that the damper
opens and closes freely.
HOUSE
WIRING
Run House Power Cable between service panel and hood location. Attach power cable to hood using
appropriate clamp (not included).
6. CONNECT THE WIRING
CAUTION
Ensure both tabs on inner top of hood are
engaged in their corresponding slots in wiring
cover. Also, take care not to pinch wires while
reinstalling wiring cover.
Reinstall wiring cover and attach it to the hood
using its retaining screw.
SCREW
MOTOR
GROUND
WIRE
HOUSE
POWER CABLE
GROUND
SCREW