Britax Maxi AHR, Инструкция по установке

Страница: 26 / 35

Instructions for Installation & Use
- Series No. 8000/B/2010
Instructions for Installation & Use
- Series No. 8000/B/2010
CHILD USE
(BOOSTER SEA
T MODE WITH CHILD HARNES
S)
50 51
CAUTION:
The lap portion of the belt must be adjusted firmly first, and then the harness, so that the belt is not
lifted off the child's lap when the harness is adjusted.
G. Finally, roll up the free end of the adjuster strap,
secure using the storage strap, then place it into
the top of the adjuster cover as shown right.
F
Fold the
adjuster strap
and secure
with Storage
Strap.
NOTE: The shoulder straps must be in the slots which
are nearest to the child’s shoulders but no lower than
the child’s shoulders. This is achieved with the headrest
slightly above the child’s shoulders.
F. With the lap belt (or converted lap/sash) adjusted to
be a firm fit on the child's thighs, then adjust the Child
Harness to remove slack in the shoulder straps. Pull
the Adjuster Strap (C) to remove slack.
Once adjusted, further adjustments are necessary only
to the upper extension straps and to accommodate the
growth of the child.
Press (A) and pull the shoulder strap (B) to lengthen.
Adjuster Cover
Storage Strap
Fully press adjuster button
(A) while pulling the Upper
Anchorage Strap (B) to lengthen.
B
C
A
Adjuster
Pull Adjuster
strap to
remove
slack
HOW TO INSTALL WITH A CHILD HARNESS HOW TO INSTALL WITH A CHILD HARNESS
D. Engage the seat belt tongue to the
buckle and adjust the seat belt
to sit firmly around the child’s
hips and thighs. The seat belt
buckle should be located as low
as possible below the child’s hip.
If using a lap-sash seatbelt and
Gated Slide you will need to adjust
it so that the seatbelt is firm on
the child’s thighs and the Gated
Slide is close to the Child but not
touching the child.
The Gated Slide
needs to be close
to the child but not
touching the child.
The Gated Slide
needs to be under
the armrest.
IMPORTANT: ALWAYS USE THE SLIDEGUARD™ CLIP
Fit the SLIDEGUARD™ clip to
the lap belt, centrally between
the shoulder straps of the
harness loops, ensuring that the
Red button of the crotch buckle
is facing forward.
Lap portion of belt must be
under armrest on both sides
Click
E. Remove SLIDEGUARD™ converter from recess area (refer to page 31 to 34), then engage into
harness buckle.
CHILD USE
(BOOSTER SEA
T MODE WITH CHILD HARNES
S)