Instructions for Installation & Use
- Series No. 8000/B/2010
Instructions for Installation & Use
- Series No. 8000/B/2010
30
HOW TO SETUP
STORING THE HARNESS
A. Disengage harness buckle. Fully lengthen the harness by pressing
the Harness Adjustment lever and pulling the harness shoulder
straps.
B. At the rear of the restraint, remove both of the harness shoulder
straps from metal Strap Connector by slipping strap through open
slot. The metal Strap Connector is shown in diagram right.
C. Pull the shoulder straps through slots in the seat back.
D. Remove the Elastic loops holding the cover in place at the lower
front of the seat. Lift the cover to expose the storage inserts in the
seat base.
E. Feed the straps with harness buckle tongues through the bottom
rear of the seat cover. Roll up the harness straps with harness
buckle tongue and place them into the left and right rear recess in
the seat base (underneath the cover).
Strap Connector
A
B
E
CHILD USE
(BOOSTER SEA
T MODE)
31
F. Remove SLIDEGUARD™ converter from storage recess and
engage into harness buckle to create the SLIDEGUARD™clip
G. Adjust the crotch strap length if necessary. See page 34.
H. Align cover and re-engage elastic loops at the front of the
cover.
I. Extend and roll up the harness adjustment strap and metal
strap connector, then store inside the recline foot.
J.
Store shoulder pads and Padded Insert (if fitted) in a safe
place, for future use.
Click
Remove SLIDEGUARD™
converter and engage in
harness buckle.
Store metal
connector in
recline foot
F
I
HOW TO SETUP
CHILD USE
(BOOSTER SEA
T MODE)
