Body jets are intended to be used in conjunction with other products,
such as the blending valve, diverters and stopcocks from the Bristan
pick and mix ranges in order to create a system to suit your
requirements.
COMPONENTS
1. Body jet
2. Cover plate
3. Tee connector (not supplied)
INSTALLATION
Body jets should be arranged in your system to provide the necessary
spray outlets to suit the application.
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Depending on application the body jet can be panel mounted
using a backnut (not supplied) or set into the wall on rigid pipe
work. If panel mounting care should be taken to ensure
connection can be made after securing with the backnut.
3. Connect body jet to pipe work using recommended ½” BSP
connections (not provided) with thread sealing compound where
necessary.
NOTE: - Before finishing wall turn on water supplies to check
both correct system function and for leaking from
joints/connections.
4. Complete wall finish.
5. See over the page for aftercare instructions.
INSTALLATION DIAGRAM
Multiple body jets will require installation in parallel using a pressure-
balancing loop, as shown below:
MAINTENANCE
If the fitting begins to drip
1. Turn off the water supply.
2. Unscrew face plate and remove nozzle.
3. Carefully clean seating, rubber seal and nozzle.
4. Replace rubber seal, nozzle and screw on face plate.
5. Contact our help line if problem persists.
