BriskHeat ACR 3 MiniPRO Hot Bonder, Инструкция по эксплуатации

Страница: 3 / 14

© BriskHeat
®
Corporation. All rights reserved.
5
ACR
®
3 MiniPRO™ Hot Bonder
GETTING TO KNOW YOUR ACR
®
MiniPRO
TM
Hot Bonder
Full-Color Touchscreen
Interface
Type J Thermocouple
Main Power Switch and
Circuit Breaker Switches
Inputs Vacuum Hose Inputs.
Vacuum Adjustments, and
Vacuum Pump Switch
Power Input Receptacles USB Data Port
Heater Output Receptacles
© BriskHeat
®
Corporation. All rights reserved.
6
ACR
®
3 MiniPRO™ Hot Bonder
SPECIFICATIONS
General

Single zone

8.4” (213mm) touch screen with easy-to-use interface

USB port for data transfer

Input ground fault interrupter breaker protected

Audible and visual alarms for high and low temperature / vacuum limits
Power

Input Voltage: 100-130VAC, 200-240VAC

MAINS supply voltage fluctuations up to ±10% of the nominal voltage

Transient over voltages typically found on a Category II power source: i.e.
a lighting circuit.

Frequency: 50-60Hz

20 amps maximum per zone

Maximum output rating: 240VAC, Single Phase
Environment

Intended for use in dry environments. Do not expose to spray

Altitude up to 6562ft (2000m)

Storage temperature range: -4°F to 140°F (-20°C to 60°C)

Operating temperature range: 41°F to 104°F (5°C to 40°C)

Maximum relative humidity: 80% for temperatures up to 88°F (31°C)
decreasing linearly to 50% relative humidity at 104°F (40°C)

Pollution Degree 2 (Normally only non-conductive pollution occurs,
however a temporary conductivity caused by condensation must be
expected)
Vacuum

Pressure: 27-28in Hg (13.26-13.75PSI)

Flow: 5.7 scfm (Vacuum Venturi)
Temperature Control

Cures up to 1400°F (760°C)

10 thermocouple sensor inputs per zone

Accepts mini Type J thermocouple connectors