© BriskHeat
®
Corporation. All rights reserved.
7
ACR
®
3 MiniPRO™ Hot Bonder
VOLTAGE:
100-130, 200-240VAC
EQUIPMENT SETUP AND START-UP
Power Input
1. Locate the surface mount connector labeled POWER INPUT on the front
panel of the Hot Bonder.
2. Align the power cord connector with the surface mount connector and
insert. The power input cord connectors are keyed to prevent improper
connections.
3. Turn the locking ring clockwise 1/2 turn to lock the cord into place. The
power cord must be fully inserted and locked for proper operation.
4. Connect the power input cord to the properly rated power supply.
NOTE: A built in safety device prevents the application of the incorrect voltage to a heat
blanket. If the incorrect voltage is applied to the Hot Bonder, the safety circuit prevents
the heater from being powered.
Starting Up
1. Flip the circuit breaker switch to the ON position.
Heater Output Power Cord Attachment
1. Locate the surface mount connector labeled HEATING POWER for the
specific zone to be used on the front panel of the Hot Bonder.
2. Align the cord connector with the surface mount connector and insert. The
connectors are keyed to prevent improper connections.
3. Turn the locking ring clockwise 1/2 turn to lock the cord into place. The
cord must be fully inserted and locked for proper operation.
Read and understand this entire manual
before operating this hot bonder.
© BriskHeat
®
Corporation. All rights reserved.
8
ACR
®
3 MiniPRO™ Hot Bonder
Temperature Sensor Attachment
The ACR
®
MiniPRO™ Hot Bonder uses Type J thermocouples for
temperature input. There are 10 sensor inputs per zone.
Connect thermocouple sensors as required. The program to be run will
determine the number of sensors necessary.
Vacuum Hose Connect
The ACR
®
MiniPRO
TM
requires a vacuum hose for proper vacuum operation.
The hose is for the vacuum source. No monitoring capabilities.
The vacuum connectors are self-sealing and designed for quick disconnect
allowing it to be operated by one hand.
1. Attach the female end of the vacuum source hose to the port marked VAC
CONNECT and the other to the vacuum port on the repair.
Vacuum Venturi
The vacuum venturi converts compressed air to vacuum.
1. Attach a compressed air source to the AIR INLET port. The air must be
clean and dry to avoid problems with the Venturi system. It is
recommended to utilize an in line filter system for the compressed air.
2. Adjust the inlet air pressure to 80 PSI.
