To obtain your favorite smoke flavor, experiment by using chunks, sticks or
chips of flavor producing wood such as hickory, pecan, apple, cherry, or
mesquite. Most fruit or nut tree wood may be used for smoke flavoring. Do
not use resinous wood such as pine as it will produce an unpleasant taste.
Wood chunks or sticks 3" to 4" long and 1" to 2" thick work best. Unless
the wood is still green, soak the wood in water for 30 minutes or wrap
each piece in foil and tear several small holes in the foil to
produce more smoke and prevent the wood from burning too quickly. A lot
of wood is not required to obtain a good smoke flavor. A recommended
amount for the Vertical Smoker is 5 to 6 wood chunks or sticks. Experiment
by using more wood for stronger smoke flavor or less wood for milder
smoke flavor.
Additional flavoring wood should not have to be added during the cooking
process. However, it may be necessary when cooking very large pieces of
food. Follow instructions and cautions in the “Adding Charcoal/Wood During
Cooking” section of this manual to avoid injury while adding wood.
Flavoring Wood
11
Regulating Heat
To maintain or increase temperature, fully open air vent dampers on sides
of smoker box. If increased air circulation does not raise the temperature
sufficiently, more wood and/or charcoal may need to be added during the
cooking cycle. Follow instructions in “Adding Charcoal/Wood During
Cooking” section of this manual.
NOTE: Dry wood burns hotter than charcoal, so you may want to increase
the ratio of wood to charcoal to increase the cooking temperature.
Hardwood such as oak, hickory, mesquite, fruit and nut wood are
an excellent fuel because of their burning rate. When using wood
as fuel, make sure the wood is seasoned and dry. DO NOT use
resinous wood such as pine as it will produce an unpleasant taste.
INS_810-5503-S.qxd 11/9/09 11:05 AM Page 12
