35-DVRS31NB(N)-2
27
GLASS BEAD INSTALLATION
Included with the Brigantia fireplace is the Glass Bead Media (black). These embers are to be distributed
evenly along the length of the burner evenly. The beads should be one row deep and cover the entire burner as
shown in picture
N O T E
The glass beads come in a variety of sizes and shapes. When placing the beads take care to
not place a
“
flat
”
side of the bead on the burner ports so they would be totally covered.
Re
-
install burner shield after
panels and glass beads
have been installed
Spread beads out evenly on
burner
Fig 26
-
A
Fig 26
-
B
Silhouette Log Set Installation (Optional)
Your Brigantia Fireplace is approved for use with the Optional Silhouette Log Set. The logs come in White,
Black, and Grey. Each set comes with 2 logs and you can install a max of 4 logs in your fireplace in any color
combination you wish. To install the logs follow the directions below.
Step 1: Place the first log on the far left of the
fireplace as show. Make sure it is stable and sitting
on the burner shield at two points and leaning against
the back of the firebox
Step 2: Place the second log beside the first log but
turn the log so it faces opposite to the first log. The
log will rest two points against the rear of the firebox
and one point on the burner shield.
Step 3: Repeat this layout for the next two logs. Test
fire the unit to make sure the flame looks good.
Adjust the logs as needed.
