Brew-Boss® V2.06 Operation Manual
other electric device that requires less than 10 amps into the pump pigtail receptacle.
To test the pump, simply press the “Pump Toggle” button on the App so the prompt changes from
“Pump Off” to “Pump On” and the little green light on the button lights up.
The pump should turn on and begin circulating water (make sure the discharge hose is connected to the
accessory port!) By the way, the toggle pump button is a handy “Emergency Stop” button for the
pump any time you need to turn it off. Once pump operation is validated, repeat the steps above to
toggle the pump off.
Test the Alarm
An alarm is provided to alert you when your interaction with the system is required. To test the alarm,
enter the menu on the tablet and select the “More” entry then the “Test Alarm” entry. This will allow
you to validate the volume is set appropriately for your brew environment as well as validate the alarm
in the controller is operational.
VERY IMPORTANT!!
Test the System with a “Wet Run” with only Water
Read the entire document before attempting to brew with the system and potentially waste good
ingredients. 90% of tech support requests and issues we hear about are clearly described in this
document, but were never read. Read the entire document so you fully understand how the system
operates, then, do a “Wet Run” with only water for the entire brew process. You can use the “Wet Run”
Brew Definition file included with the application to test the entire system in a shortened amount of
time. Please do the Wet Run before trying an actual batch.
Page 21
