Brew-Boss® V2.06 Operation Manual
Look at the heater element, you should see small bubbles coming off the heater element and most of
the time, hear it heating as well. If it appears the heater is not functioning, confirm that the heater is
plugged into the controller.
Now try dragging the yellow heater power slider to the left with your finger. You should see the power
setting change. Let up on the bar and you should see the corresponding power setting on the LCD
display on the controller.
Install the Pump
The pump is marked with the direction of flow through the pump housing. Water flow is from the
kettle valve, through the pump, and then to the accessory port on the kettle.
Install the stainless steel flow restriction valve on the discharge side of the pump. Use a high quality
Teflon plumbers tape on all threaded joints. Next, install the MALE stainless steel barbed or Camlock
fittings onto the inlet of the pump and outlet port of the flow restriction valve. Do not over tighten,
especially on the plastic body pump.
Page 18
