Brew-Boss® V2.06 Operation Manual
Insert the Digital Temperature Probe
The temperature probe plugs into the controller using a headphone type stereo plug on the right side of
the controller. The system includes a weldless temperature probe coupler that allows direct contact
between the sensor and the water. This provides faster and more accurate temperature control. Install
the weldless temperature probe coupler to the 1/2” diameter hole in the kettle as shown in the drawing
below.
Care must be taken to properly install the temperature sensor. Fist, install the nut and two rubber O-
rings as shown in the picture.
Next, insert the assembly into the coupling on the kettle as shown so that about ¾ – 1 inch protrudes
into the inside of the kettle. Make certain it will not interfere with the COFI infusion filter if you are
using that device. Apply a very small amount of petroleum jelly to the O-rings for lubrication.
Page 10
