42
8.3
RESET AND FACTORY RESET
To reset the console and start again, press the
[ RESET ]
key once or remove the backup battery
and then unplug the adapter.
To resume factory settings and remove all data, press and hold the
[ RESET ]
key for 6 seconds.
8.4
WIRELESS 7-IN-1 SENSOR ARRAY MAINTENANCE
REPLACE THE WIND VANE
Unscrew and remove the wind
vane for replacement
REPLACE THE WIND CUP
1. Unscrew and remove the
top cap
2. Remove the wind cup for
replacement
CLEANING THE THERMO-
HYGRO SENSOR
3. Remove the 2 screws at the
bottom of the radiation shield.
4. Gently pull out the shield.
5. Carefully remove any dirt or
insects on the sensor (do not let
the sensors inside get wet).
6. Clean the shield with water to
remove any dirt or insects.
7. Install all the parts back when
they are clean and fully dried.
CLEANING THE RAIN COLLECTOR
1. Rotate the rain collector by turning it
30°anti-clockwise.
2. Gently remove the rain collector.
3. Clean and remove any debris or
insects.
4. Install the collector when it is clean
and fully dried.
CLEANING THE UV SENSOR AND
CALIBRATION
• For precision UV measurement,
gentle clean the UV sensor cover
lens with damp micro-fiber cloth.
• Over time, the UV sensor will
naturally degrade.
9.
TROUBLESHOOT
Problems
Solution
7-in-1 wireless sensor
array is intermittent or
no connection
1. Make sure the sensor array is within the transmission range
2. If it still does not work, reset the sensor pair with console again
Cannot use the STA
mode for setup
1. Make sure your console and smart phone are connect to the same WI-FI
network.
2. Make sure the console WI-FI signal icon are always on.
3. Make sure the location function of your smart phone is enabled.
4. Ensure your APP are the latest version.
No WI-FI connection
1. Check the WI-FI icon on the display, it should be on if connectivity is
successful.
2. In the console SETUP page, make sure the WI-FI settings (router's name,
security type, password) are correct.
3. Make sure you connect to 2.4G band of the WI-FI router (5G not
supported)
Data not reporting to
ProWeatherLive
1. Make sure the WI-FI connection of the console is good.
2. In the console SETUP page, ensure your Station ID and Station Key are
correct.
Rainfall is not correct
1. Make sure the rain collector is clean for the tipping bucket to tip smoothly.
2. Make sure the sensor has stable and level mounting to ensure correct
tipping.
Temperature reading too
high in the day time
1.
Place the sensor in open area and at least 1.5m off the ground.
2. Ensure that the sensor is placed away from heat generating sources or
structures, such as buildings, pavement, walls or air conditioning units.
