32
4.5.3 SETTING ALARM TIME AND ICE ALERT
In normal time mode, press and hold
[ ALARM ]
key for 2 seconds
to enter alarm / alert setting mode.
Then press
[ SET ]
key to proceed with next step of the setting. Please refer to the following
setting procedures.
Step
Mode
Setting procedure
[ALARM]
+2s
Time alarm
Press
[ / MOD ]
or
[ / NDX ]
key to adjust the time.
Press
[ ALARM ]
key to toggle the alarm on /off.
Press
[ ALARM ]
key to toggle the ice-pre alarm on /off.
[SET]
Exit setting mode
NOTE:
-When you turn on the time alarm, the " " icon will display on time section.
-During the setting, press and hold the
[ / MOD ]
or
[ / NDX ]
key for quick-adjusting the value.
-The alarm function(s) will turn on automatically once you set the alarm time.
-During the setting, you can back to normal mode by press and hold
[ SET ]
key for 2 seconds.
4.5.3.1 VIEW AND ACTIVATING ALARM TIME / TEMPERATURE PRE-ALARM
1. In normal mode, press
[ ALARM ]
key to show the alarm time for 5 seconds.
2. When the alarm time displays, press
[ ALARM ]
key again to activate the alarm function. Or
press
[ ALARM ]
key twice to activate the alarm with ice pre-alarm function.
Alarm off
Alarm on
Alarm with ice-alert
NOTE:
Once the ice pre-alert activated, the alarm will sound 30 minutes earlier if it detects outside temperature is
below -3°C.
4.5.3.2 ALARM OPERATION
If you set the time alarm, and reach the time that you set, alarm sound will start.
Where it can be stopped by following operation:
-Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in the next day.
-By pressing
[ ALARM / SNOOZE ]
key to enter snooze that the alarm will sound again after 5 minutes.
-By pressing and hold
[ ALARM / SNOOZE ]
key for 2 seconds or press
[ ALARM ]
key to stop the alarm
and will activate again in the next day.
NOTE:
-The snooze could be used continuously in 24 hours.
-During the snooze, the alarm icon "
" will keep flashing.
4.5.4 BACK LIGHT
The console back light brightness can be adjust by using the
[ BACKLIGHT ]
slide switch to
select the appropriate brightness:
- Slide to the
[ HI ]
position for the brighter back light.
- Slide to the
[ LO ]
position for the dimmer back light.
- Slide to the
[ AUTO ]
position for the auto adjust back light that according to environment light
level
