Brave VH1724GC, Руководство пользователя

Страница: 41 / 62

41
Assembly Instructions
NOTE:
Do not over-tighten filter. This will cause difficulties in removing filter for periodic maintenance.
Step 3 – Install Filter

CAUTION: Never back off an installed pipe fitting to achieve proper
alignment. Loosening installed pipe fittings will corrupt the seal and
contribute to leakage and failure.

Screw finger-tight (1) Return Line Filter Head onto hydraulic tank
return port.
NOTE: The arrow on filter head should point towards the
tank. Also, thread sealant is already in place on hydraulic tank return
port.

Wrench-tighten the filter head to 1.5-3.0 Turns Past Finger Tight
position. Consider final orientation position as to not exceed the
recommended Turns Past Finger Tight. Properly assembled fittings
total thread engagement should be 3.5-6 turns.

Lightly coat Return Line Filter Canister seal with oil.

Screw finger-tight (1) Return Line Filter Canister onto bottom of
return line filter head until gasket makes contact and continue until
hand tight. Then, tighten filter an additional 1/2 turn with oil filter
wrench.

Screw finger-tight (1) Filter Fitting into the return line filter head.

Wrench-tighten the fitting to 1.5-3.0 Turns Past Finger Tight position.
Hold filter head with another wrench to keep it from turning past its
desired position. Consider final orientation position as to not exceed
the recommended Turns Past Finger Tight. Properly assembled fittings
total thread engagement should be 3.5-6 turns, and fitting orientation
should be as shown below (45° angle toward tow bar).
Tools Needed

(2) Adjustable
Wrenches

Oil Filter Wrench
Part # 778827
Return Filter Fitting
Qty: 1
Fittings Needed from Parts Bag:
Hydraulic Tank
Return Port