Brandt GRAIN VAC 5000, Руководство оператора и каталог запасных частей

Страница: 12 / 104

11
Transport Position
1.3 Hitch Clevis
The hitch clevis plate has been installed in the top
position for shipping and it should be relocated to
the lower working position before delivering to the
customer. As shown in the figure below, remove
the 3/4” locknuts, spacer tubes, and hitch plate and
re-install in the lower position.
In addition, the hose holder spring has been installed
inside out and rotated back. Remove the spring
retainer nut, pull off the spring and flip inside out so
that the coil is laying above the frame member.
Reinstall the retaining nut and secure with the spring
in the vertical position.
Rotate the Pail Hook into working position
Lower Tube
1.4 Pail Hook
The Pail Hook has been installed in the stowed
position for shipping and it should be relocated to
the working position before delivering to the customer.
As shown in the adjacent figure, remove the 3/8”
locknut and re-install in the working position.
1.5 PTO Clutch Run- In Procedure
The Clutch on the PTO Shaft has a run-in procedure
that is required to be done before the vac is put to
use. Refer to Section 5.18, page 56 of this manual
for the run-in instructions.