Brady BradyJet J4000, Руководство пользователя

Страница: 42 / 48

BradyJet J4000 User Manual
36
* The reflective/black mark should be opaque to infrared light. The mark should be between the labels.
The end of the mark should correspond with the beginning of the label.
** This is the recommended maximum. There are two factors that determine whether the printer will
accept any particular stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the backing if the sensor is set to die-cut.
If you are printing in continuous or reflective label sensing mode number 2 does not apply. The fact
that the printer must read through the backing in die-cut mode will limit the thickness much more than
the printer's ability to pull the paper through the print area. However, if you adjust the opacity level of
the liner enough to allow the label to be seen by the stock sensor, the thickness will only be limited by
the printer's ability to pull it through the printer area. For these reasons the weight or thickness of the
liner is a variable that can not easily be defined. It is recommended to use a 40# liner with all label
supply.
IMPORTANT! Test all supply with the printer before ordering large quantities!
Max Min
Label width 8.25" (209mm) 0.5" (13mm)
Liner/media width 8.375" (212mm) 1.5" (38mm)
Label height/length 24" (609mm) 0.5" (13mm)
Gap between labels 10" (253mm) 0.10" (2.5mm)
Width of through-hole opening 0.5" (12.65mm) 0.25" (6.325mm)
Gap Sensor Adjustment Range (from left edge) 1.9" (48mm) 0.20" (5.06mm)
Reflective/Black N/A 0.1" (2.54mm)
Mark Width* Not Applicable 0.1" (2.54mm)
Max Outer Diameter (OD) 6.0"(152.4mm) Not Applicable
Inner Core Diameter (ID) 3.0" (76.2mm) 3.0" (76.2mm)
Total Thickness (Liner + Label)** .0010" (10 mil) Not Applicable
Distance from edge of media to edge of label Printer driver assumes 2 mm gap.
However, this is adjustable via the left
margin offset.