Brady BradyJet J4000, Руководство пользователя

Страница: 22 / 48

BradyJet J4000 User Manual
16
Through-hole Supply
Adjusting the Gap Sensor
Circular Label Supply
When using circular supply, adjust the gap sensor to correspond with the very top of the label where
the circles are closest together. If the sensor is too far to the right or left the printer will still sense the
label but the image may be offset downward because the printer will start printing at the wrong
position. If you are using supply that has multiple labels across make sure the sensor corresponds to a
place on the supply that has a label and not a vertical gap.
The gap sensor can only be moved a maximum of 2 inches from the left side of the printable area.
Which means that the maximum diameter circular label that can be printed is 4 inches. For supply
larger than 4 inches in diameter, you must have a black mark printed on the back of the supply and
change the supply sensor mode to reflective. The printer will now look for the black mark representing
the beginning of the next label instead of the die-cut. For more information see “Setting the Supply
Sensor Mode” on page 21 . Set gap sensor to 1 1/8" for 2" circular label (1/8" liner edge gap).
Through-hole Supply
If you are using card stock or supply that has a hole punch or a notch to identify a transition from
backing to label, you can adjust the supply sensor to position it over the identifying mark.
Center of hole
Center of circle
Through-hole Supply
Circular Supply