Bradley Keltech HL Series, Руководство по установке

Страница: 19 / 49

19
Installation
HL-Series Tankless Heater
Bradley • 215-1823 Rev. F; ECN 18-17-017 3/29/2018
Table of Parameters for DC Option: RS-485 Modbus
Parameter Name Range Map 1 Map 2 Default Data Type
Read/
Write HL Series Meaning
Analog Input -1999 .000 to 9999 .000°F
-1128 .000 to 5537 .000°C
360 360 -- FLOAT R Process Value
Analog Input Error None (61)
Open (65)
Fail (32)
Shorted (127)
Measurement Error (140)
Bad Calibration Data (139)
Ambient Error (9)
RTD Error (141)
Not Sourced (246)
362 362 None UINT R Process Value Sensor Error
Calibration Offset -1999 .000 to 9999 .000°F
-1128 .000 to 5537 .000°C
382 382 Factory Set FLOAT RWES Process Value Calibration
Digital in 5 Inactive (41)
Active (5)
1328 1568 -- UINT R Flow Activation
Digital out 6 Off (62)
On (63)
1042 1162 -- UINT R AL Only Alarm Status
EZ-KEY Inactive (41)
Active (5)
1368 1608 -- UINT R EZ-Key
Control Mode Active Off (62)
Auto (10)
Manual (54)
1882 2362 Auto UINT R Control Loop Mode
Heat Power 0 .0 to 100 .0% 1904 2384 -- FLOAT R Duty Cycle Output %
Set Point -1999 .000 to 9999 .000°F
-1128 .000 to 5537 .000°C
2172 2652 -- FLOAT R Heater Set Point
Remote Set Point No (59)
Yes (106)
2200 2680 No UINT RWES Remote Set Point Enable
Remote Set Point Type Auto (10)
Manual (54)
2202 2682 No UINT RWES Remote Set Point Control Mode
Process Value -1999 .00 to 9999 .000°F
-1128 .000 to 5537 .000°C
402 402 FLOAT R Process Value
Control Mode OFF (62)
Auto (10)
Manual (54)
1880 2360 Auto UINT RWES Control Loop Mode
Close Loop Set Point 40-160 std
40-170 T170 Option
40-180 T180 Option
40-190 T190 Option
40-200 T200 Option SPCL
2160 2640 Factory Set FLOAT RWES Heater Set Point
Open Loop Set Point 0 to 100% 2162 2642 -- FLOAT RWES Manual Mode Set Point
Display Units Fahrenheit (30)
Celsius (15)
1838 2308 °F UINT RWES Controller Display Units
Address Modbus 1-247 2482 2962 1 UINT RWE Modbus Address
Baud Rate 9600 (188)
19200 (189)
38400 (190)
2484 2964 9600 UINT RWE Modbus Baud Rate
Parity Modbus None (61)
Even (191)
Odd (192)
2486 2966 None UINT RWE Modbus Parity
Modbus Units Fahrenheit (30)
Celsius (15)
2490 2970 °F UINT RWE Communication Units
Modbus Word Order Low-High (1331)
High-Low (1330)
2488 2968 Low-High UINT RWE Modbus Word Order
Non-Volatile Save Yes (106)
No (59)
2494 2974 Yes UINT RWE If set to yes, all values to the control will
be saved from EEPROM
NOTICE! For adjusting Modbus address, baud
rate and parity, customer needs to set
on Watlow controller per Watlow manual.
Legend
uint = Unsigned 16 bit int
dint = Long 32 bit
string = ACSII (8 bit per character
float = IEEE 754 32 bit
RWES = R eadable, W ritable, E EPROM (saved), User S et (saved)