5
INSTALLATION
LOCATING THE WATER HEATER
This water heater MUST NOT be installed in any location where
gasoline or flammable vapors are likely to be present, unless the
installation is such to eliminate the probable ignition of gasoline or
flammable vapors.
Water heaters in residential garages shall be installed so that all
burner(s) and burner ignition device(s) are located not less than 18
inches
(45.7 cm)
above the floor and be located, or protected, to avoid
physical damage. For other installations refer to local codes. In the
absence of local codes, the water heater shall be installed in
compliance with the National Fuel Gas Code, (ANSI Z223.1- Latest
Edition), or in Canada CAN/CGA B149.1 Natural Gas Installation Code
(Latest Edition) or CAN/CGA B149.2 Propane Installation Code (Latest
Edition).
The location of this water heater is of the utmost importance. Before installing
this water heater, you should read the Installation section of these
instructions. After reading these Installation and Operating Instructions, select
a location for the water heater where the floor is level and is easily accessible
to gas and water supply lines.
DO NOT locate the water heater where water
lines could be subjected to freezing temperatures
.
Make sure the cold
water pipes are not located directly above the gas control so that
condensate during humid weather does not drip on the controls
.
WARNING
Water heaters are heat producing appliances. To avoid damage or injury
there shall be no materials stored against the water heater or vent-air
intake system and proper care shall be taken to avoid unnecessary contact
(especially by children) with the water heater and vent-air intake
components.
UNDER NO CIRCUMSTANCES SHALL FLAMMABLE
MATERIALS, SUCH AS GASOLINE OR PAINT THINNER BE USED OR
STORED IN THE VICINITY OF THIS WATER HEATER, VENT-AIR
INTAKE SYSTEM OR IN ANY LOCATION FROM WHICH FUMES
COULD REACH THE WATER HEATER OR VENT-AIR INTAKE
SYSTEM.
6
Installation (Locating The Water Heater) continued-
Water heater corrosion and component failure can be caused by the heating
and breakdown of airborne chemical vapors. Examples of some typical
compounds that are potentially corrosive are: spray can propellants, cleaning
solvents, refrigerator and air conditioning refrigerants, swimming pool
chemicals, calcium and sodium chloride, waxes and process chemicals.
These materials are corrosive at very low concentration levels with little or no
odor to reveal their presence.
NOTE: DAMAGE TO THE WATER HEATER
CAUSED BY EXPOSURE TO CORROSIVE VAPORS IS NOT COVERED
BY THE WARRANTY. DO NOT OPERATE THE WATER HEATER IF
EXPOSURE HAS OR WILL OCCUR. DO NOT STORE ANY
POTENTIALLY CORROSIVE COMPOUNDS IN THE VICINITY OF THE
WATER HEATER.
WARNING
Liquefied petroleum gases/propane gas are heavier than air and will
remain at floor level if there is a leak. Basements, crawl spaces, closets
and areas below ground level will serve as pockets for accumulation of
leaking gas. Before lighting, smell all around the appliance area for gas.
Be sure to smell next to the floor.
IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any telephone in your
building.
•
Immediately call your gas supplier from a neighbor’s telephone.
Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
DO NOT OPERATE APPLIANCE UNTIL LEAKAGE IS CORRECTED!
Содержание mi5036en10
Страница 14: ...27 FIGURE 6 FIGURE 7 28 NOTES...
