Other possible solutions:
NOTE: BE SURE ELECTRICITY IS TURNED OFF BEFORE PROCEEDING
STEP ONE:
Make sure the printed circuit board is mounted in the correct position. This is the top
set of mounting holes (See diagram below). Failure to mount PCB in the correct
position will cause element burn out and may cause further damage to the unit
(This board may have been incorrectly positioned if serviced previously).
The correct mounting holes
for the PCB on an “ES,EFC,
EFT” model.
Board mounted in correct
position
Inlet filter
STEP TWO:
Inspect the inlet filter (See diagram above for location). Make sure the inlet filter
screen is free from debris, pipe dope or any other foreign materials that may prevent
adequate water flow.
6
