Page 9
UG_RGW_v1.12_EN
7.0 Preparation
To prevent damage due to shipping vibration, several components of the system have been unin-
stalled after testing and must be reinstalled prior to system installation and start-up.
The tools and materials needed to reinstall these components are:
12mm wrench
Phillips head screwdriver 7
Liquid Teflon (preferred) or Teflon tape.
8
Power Transformer:
Connect the 24V DC power transformer to the AC power cord. Connect the 24V DC jack into the
corresponding slot marked “ELECTRICITY” found on the outside of the upper portion of the RGW
system. Do not connect the AC power cord to the AC outlet at this time.
Clean Out Drain Valve:
The clean out drain valve is a 1” socket and 1" male threaded PVC ball valve and is included in the
installation kit. Apply Teflon to the male threads of ball valve and screw into the bottom of the tank by
hand until it is snug, being careful not to cross-thread. Orientate so the valve handle is on top.
Suction Foot Valve Unit :
This assembly is identified by a plastic foot valve on one end and a grey PVC elbow with a
stainless steel flange attached at the other end. Remove two bolts and rubber gasket from
the side of the pump. Fill the pipe with approximately 2 liters (.5 gal.) of water through the
elbow. Place the foot valve end of the pipe through the 2” hole closest to the centre of the
black platform disk and lower the pipe until the steel flange aligns with the corresponding
mating surface on the pump.
Press the black rubber grommet found on the pipe, into the 2” hole on the black support
disc to make the proper seal. Securely attach the flange and gasket to the pump with the
two bolts using a 12 mm wrench.
Water Level Sensor Unit:
This assembly is identified is identified as a long grey pipe with an electrical wire and con-
nector exiting from one end. Use the yellow rubber gasket (supplied) and gently slide it over
the pipe up against the PVC flange. Place the end opposite of the wires through the 1-3/8”
hole near the edge of the platform disk and lower the pipe until the PVC flange rests on the
black support plate. Secure with three Phillips screws (supplied) using a Phillips head screw-
driver. Connect the level sensor pipe’s electrical connector to the vacant connector on the
wiring harness.
