BOXLIGHT MP-56t, Руководство пользователя

Страница: 38 / 48

38
LAMP REPLACEMENT
LAMP REPLACE
When the life of the Projection Lamp draws to an end, the LAMP
REPLACE indicator lights yellow. When this indicator lights yellow,
replace the projection lamp with a new one promptly.
Turn off the projector and disconnect the AC plug. Allow the
projector to cool for at least 45 minutes.
Loosen the 2 lamp assembly screws with a screwdriver and pull
out the Lamp Assembly by grasping the Handle and pulling up.
1
3
Replace the Lamp Assembly with a new one and replace the 2
screws. Make sure that the Lamp Assembly is set properly.
Replace Lamp Cover and tighten the screw. 4
Remove the Lamp Cover screw and remove the Lamp Cover. 2
Connect AC Power Cord to the projector and turn on the
projector.
6
Follow these steps to replace the lamp assembly.
Reset the Lamp Replace Counter.
Refer to “LAMP REPLACE COUNTER” on the next page.
5
LAMP
ASSEMBLY
HANDLE
LAMP COVER
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through Boxlight Corporation at 1-800-762-5757 or 360-779-7901.
When ordering Projection Lamp, give following information to dealer.
●
Model No. of your projector : BOXLIGHT MP-56t
●
Replacement Lamp Type No. : POA-LMP59
(Service Parts No. 610 305 5602)
For continued safety, replace with a lamp assembly of
the same type.
Do not drop the lamp assembly or touch the glass bulb!
The glass can shatter and may cause injury. Allow a projector to cool, for at least 45 minutes before
you open Lamp Cover. The inside of a projector can
become very hot.
SELECT
ON-OFF
This indicator lights yellow
when the life of the projection
lamp draws to an end.
Replace the Projection Lamp
with a new one promptly.
TOP CONTROL
CAUTION
SCREW
SCREWS
APPENDIX