BOXLIGHT MP-56t, Руководство пользователя

Страница: 19 / 48

19
BASIC OPERATION
TURNING ON PROJECTOR
Connect the projector's AC Power Cord into an AC outlet. LAMP
Indicator lights RED, and READY Indicator lights GREEN. 2
3
TURNING OFF PROJECTOR
Press POWER ON-OFF on Top Control or on Remote Control,
and a "Power off?" message appears on a screen.
Press POWER ON-OFF again to turn off the projector. The
LAMP Indicator lights bright and READY Indicator turns off.
After the lamp is turned off, the Cooling Fans operate (for 90
seconds). During this "Cooling Down" period, the projector
cannot be turned on and will not respond to user input.
1
2
TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN
PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE
TURNING IT OFF.
TURNING ON / OFF PROJECTOR
1 Complete peripheral connections (with Computer, VCR, etc.)
before turning on projector. (Refer to "CONNECTING
PROJECTOR" on pages 11~13 for connecting the equipment.)
3 When the projector has cooled down, the READY Indicator lights
GREEN again and you can turn the projector back on or
disconnect the AC Power Cord.
Power off?
Message disappears after 4 seconds.
When “Power Management” is ON, the projector detects signal interruption and turns off the Projection Lamp automatically.
Refer to “Power management” on page 37.
NOTE : When “On start” function is ON, this projector is turned
on automatically by connecting AC Power Cord to an
AC outlet. (Refer to page 37.)
Press POWER ON-OFF on Top Control or on Remote Control.
LAMP Indicator dims, and Cooling Fans start to operate.
Preparation Display appears on screen and count-down starts.
The signal from PC or Video source appears after 30 seconds.
Current Input position and Lamp mode status are also displayed
on screen for 5 seconds. (Refer to "LAMP MODE" on page 37.)
30
Preparation Display disappears after 30 seconds.
Computer 1
Input position and
Lamp mode status
When the WARNING TEMP. indicator flashes red, the projector automatically shuts off. Wait at least 5 minutes, when the
READY indicator lights green the projector may be turned on by pressing the POWER ON-OFF button.
When both WARNING TEMP. and READY indicators are flashing, the projector cannot be turned on by pressing the
POWER ON-OFF. In this case, follow procedures below:
1. Disconnect AC Power Cord from the AC outlet.
2. Turn the projector on again. (Refer to steps 2-3 of TURNING ON PROJECTOR on this page.)
When the WARNING TEMP. indicator continues to flash, follow procedures below:
1. Disconnect AC Power Cord from the AC outlet.
2. Check Air Filters for dust accumulation.
3. Clean Air Filters. (See "AIR FILTER CARE AND CLEANING" section on page 41.)
4. Turn the projector on again. (Refer to steps 2-3 of TURNING ON PROJECTOR on this page.)
If the WARNING TEMP. Indicator should still continue to flash, call Boxlight Corporation at 1-800-762-5757 or 360-779-7901.