
22
Serial Port Configuration:
•
COM Port
– Selects between the 2 available COM ports on the CM900 .
NOTE:
In an ELEVATE system, COM port 2 will not
normally be available because it is dedicated to the Base Station .
•
Baud Rate
- Specifies the data speed at which this device should communicate with the attached serial device; while 9600
and 19200 are typical for projectors, data speeds vary by manufacturer .
•
Stop Bits
- Specified by the manufacturer of the connected serial device, but is typically 1 .
•
Parity
- Specified by the manufacturer but is typically None .
•
Set to input control mode
(COM Port 2 only) - Sets the second serial port to a mode where it accepts incoming serial
commands to control things like volume .
NOTE:
This setting will not normally be available in an ELEVATE system .