BOXER KING 5600, Руководство по обслуживанию

Страница: 126 / 140

Service Manual 04/2010 Rev.B
126
Fig.303
Fig.304
Install the tang #1 (Fig.296).
Mount the plastic pulley and the belts.
Make the pulleys alignment and belts tension
following 5.9.
Turn on the machine.
Make the chuck running and check if the it
turns quietly.
Check in four points of the chuck if there is
play between crown and worm screw.
Lift the chuck arm ‘till end of the stroke.
Make the chuck running and check that there
is any oil leaking through the silicon.
Install the belts protection 5.9.
7.21 WORM SCREW SEAL: CHECK
AND REPLACEMENT
: 2h
: End wrenches 13,19,22mm, socket wrench
22 and 24mm, 13mm tube type wrench,
12mm Allen wrench, big standard screwdriver,
rubber hammer, silicon.
L
: The defective worm screw seal may cause
the following inconvenience:
1. Oil leaking.
TO CHECK THE SEAL:
Turn the machine off and remove the belts
protection 5.9.
Check if there is oil leaking around the pulley.
TO REPLACE THE SEAL:
Remove the front worm screw support
(Fig.305) by removing the screws #3 and #4
(
7.20 Fig.298).
Fig.305
Lock the support on a vice and remove the
seal (Fig.306).
Fig.306
Take the new seal and place it on the support.
Take a piece of wood of the same seal width
and insert the new seal in the support
(Fig.307).