9000 Series Air Seeder
Service & Maintenance
10.57
3. Measure the center to center distance at the front
of the tires and then at the back of the tires.
a. The front of the tires should be closer
together than the back by 0" to 1".
b. To adjust this distance:
i.
Remove the pin in the "tire" end of
the tie rod clevis.
ii.
Loosen the jam nut on the end of
the clevis.
iii. Turn the clevis in the direction for the
adjustment required.
iv. The distance to be adjusted should be
split equally between the two sides.
Example, if the distance to be adjusted
is 1/2" adjust each side by 1/4".
c. Check the distance again between the fronts
and rear of the tires.
4. If needed re-adjust the clevises again.
5. If the distance in
Step 3a
is met,
a. Tighten the jam nut on the end of the clevis,
b. Replace the pin in the end of the clevis.
6. Always ensure that the front tires are square in
relation to the direction of travel.
10.3.12 Bolted-On Rear Axle
Refer to
Figure 10.64
.
1. Retorque rear axle bolts to
600 +/- 50 FTLB (814 +/- 68 N m):
a.
When new, after first 10 hours of
operation;
b. After 50 hours of operation;
c. Annually, thereafter.
Figure 10.64 - Rear Axle Bolts
Rear Axle Bolts
Rear Axle Bolts
