NL Troubleshooting
Malfunction
Cause and Troubleshooting
Vibration and movement
▶
Remove transport locks
of the appliance
during the spin
run.
Drum is spinning, er
Load recognition is active.
▶
No error, no action necessary.
no water flows into
the appliance.
Note: The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric softener
ter with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶
During the next wash, reduce by an equal amount.
load the amount of detergent.
High spin speed
rental is not
reached.
Low spin speed is set.
▶
For the next wash, set a higher spin
speed in.
Unbalance control system compensates for
imbalance through reduced spin speed.
▶
Redistribute the laundry in the drum.
Note: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
▶
Start the program Centrifuge.
Program centrifugal
run does not start.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and water drain
feed hose is not kinked or pinched.
The unbalance detection system has aborted the spin
due to uneven distribution of the laundry.
▶
Redistribute the laundry in the drum.
Note: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes distributes itself better when spinning.
▶
Start the program Centrifuge.
62
