Bosch VIP XD, Инструкция по установке и эксплуатации

Страница: 74 / 86

Installation and User Guide | VIP XD EN | 74
Appendix Bosch Security Systems | 2005-05 | V1.0
No connection
established, no
image transmission. The unit's configuration. Check all configuration
parameters.
Faulty installation. Check all cables, plugs, contacts
and connections.
Wrong IP address. Check the IP addresses (terminal
program).
Faulty data transmission
within the LAN. Check the data transmission with
ping .
The maximum number of
connections has been
reached. Wait until there is a free connection
and call the transmitter again.
The unit does not
report an alarm. Alarm source is not selected. Select possible alarm sources on
the Alarm sources configuration
page.
No alarm response
specified. Specify the desired alarm response
on the
Alarm connections
configuration page, if necessary
change the IP address.
Control of cameras
or other devices is
not possible. The cable connection
between the serial interface
and the connected device is
incorrect. Check all cable connections and
ensure all plugs are properly
plugged in.
The interface parameters
conflict with those of the
other device connected. Make sure the settings of all
devices involved are compatible.
The unit is not
operational after
firmware upload. Power failure during
programming by the update
file. Have the unit checked by
Customer Service and replace if
necessary.
Incorrect update file. Enter the IP address followed by
/main.htm
in your web browser
and repeat the upload.
Malfunction Possible causes Solution