Bosch VIP XD, Инструкция по установке и эксплуатации

Страница: 19 / 86

VIP XD | Installation and User Guide EN | 19
Bosch Security Systems | 2005-05 | V1.0 Installation
Setup using a terminal program
Data terminal
You can connect a data terminal to the VIP XD for setup and local control. The
data terminal consists of a computer with terminal software. You can use the
configuration cable supplied for the connection (for assignment on the orange
terminal block, see page 76).
HyperTerminal, a communications accessory included with Microsoft Windows,
can be used as the terminal program.
Note
Information on installing and using HyperTerminal can be found in the user
guides or online help for MS Windows.
– Before using the terminal program, disconnect the VIP XD from the data
network and disconnect the power supply unit from the mains socket.
– Connect the open lines of the configuration cable to the terminal block that is
already connected to the power supply unit. The assignment can be seen
from the labels on the configuration cable and the markings on the terminal
block.
– Connect the terminal block to the orange socket on the unit.
– Connect the VIP XD configuration cable to a free serial port on your
computer.
– Ensure that the correct primary adapter is fitted and connect the power supply
unit to an appropriate mains socket.
Configuring the terminal
To establish communication between the terminal program and the VIP XD, the
transmission parameters must be correctly defined. The following values should
be set in the terminal program:
]
19,200 Bit/s
]
8 data bits
]
No parity check
]
1 stop bit
]
No protocol