52
en
Service Programmes
Insert Bosch cleaning tablet
and close drawer
■
Drop a Bosch cleaning tablet in the
drawer
18
and close.
Remove filter
start
Info:
If the water filter
29
is activated, the
display will prompt you to remove the filter
29
, then press the
start
button
8
again.
Add 0.5 l water and descaler
start
■
Pour lukewarm water into the empty
water tank
11
up to the
“0.5l”
mark and
then dissolve 1 Bosch descaling tablet
TCZ8002 in it.
■
Press the
start
button
8
. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid
start
Info:
If there is not enough descaling
solution in the water tank
11
, the
corresponding prompt is displayed. Pour
in descaling solution and press the
start
button
8
again.
Clean and refill water tank
start
■
Rinse the water tank
11
and refill it with
fresh water up to the “
max
” mark.
■
Press the
start
button
8
. The descaling
programme now runs for about 1 minute
more, followed by the cleaning programme
for about 7 minutes, and rinses the
appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
■
Empty the drip tray
23
and reinsert it.
Replace the filter if one is being used. The
appliance has completed descaling and
cleaning and is ready for use again.
Important:
Wipe down the appliance using a
soft, damp cloth to immediately remove any
descaler residue. Such residue can cause
corrosion. New sponge cloths may contain
salts. Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
Thoroughly clean the suction pipe
10d
of
the milk frother.
Note:
If one of the service programmes
is interrupted, e. g. by a power outage,
proceed as follows:
■
Rinse the water tank
11
and refill it with
fresh water up to the “
max
” mark.
■
Press the
start
button
8
. The cleaning
programme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
■
Empty the drip tray
23
and reinsert it.
The appliance is ready for use again.
