en
Trouble shooting
48
--------
Notes
■
If
“
appears in the display, the sensor for the
relevant hotplate must be pressed and held in order
to read the fault code.
■
If the fault code is not listed in the table, disconnect
the hob from the power supply, wait 30 seconds and
connect it again. If the display appears again,
contact technical after-sales and tell them the
precise fault code.
The temperature sensor indi-
cator is not lighting up
The temperature sensor is not responding and
the indicator is not lighting up.
Replace the 3 V CR2032 battery. See the section entitled
If this does not solve the problem, press and hold the symbol on
the temperature sensor for 8 seconds and then reconnect the
temperature sensor to the hob.
If the problem persists, contact the technical after-sales service.
The indicator on the tempera-
ture sensor flashes twice.
The battery in the temperature sensor has almost
run out. You may be interrupted the next time you
cook by the battery running out.
Replace the 3 V CR2032 battery. See the section entitled
The indicator on the tempera-
ture sensor flashes three
times.
The temperature sensor is disconnected.
Press and hold the symbol on the temperature sensor for 8 sec-
onds and then reconnect the temperature sensor to the hob.
“Š‹‹‹
“Š‹‚‹
The operating voltage is incorrect/outside of the
normal operating range.
Contact your energy supplier.
—…‹‹
The hob is not connected properly
Disconnect the hob from the power supply. Check that it has been
connected as shown in the circuit diagram.
š“
Demo mode is activated
Disconnect the hob from the power supply. Wait for 30 seconds
before reconnecting it. Touch any touch control in the next
3 minutes to deactivate demo mode.
Do not place hot pans on the control panel.