1 699 200 077
2017-06-26
|
Robert Bosch GmbH
| MTS 6520 VCI | 31
en
5.
Select the Network Setup tab.
6.
Select the Wireless tab.
7.
Select the Enable Wireless Interface check box in
the Interface Control section. Once you enable the
interface, the IP Address Configuration box and the
Apply and Cancel buttons become active.
8.
Select Obtain an IP address automatically if your
LAN automatically assigns IP addresses. Otherwise
enter the assigned IP Address and Subnet mask
given to you by your IT Administrator.
9.
Select Access Point to begin wireless access point
configuration.
10.
Specify the network name:
i
If you are not within range of the access point you
will use, select the Enter Network Name [SSID]:
radio button and type the network name.
i
If you are within range of your wireless access point,
choose the Select from available network list radio
button and then select Refresh to cause the VCI to
search for wireless network signals. The detected
networks are displayed in the Network Name box.
11.
After you have entered the network name, select
Configure.
12.
Enter the security settings that are required by your
network, then select Next.
13.
Select Yes to reconfigure your VCI, or if you want to
start over select No.
14.
Choose the Properties tab to verify that the VCI is
configured correctly. You can also disconnect the
USB cable to verify that the wireless connection is
working.
15.
Record or print your settings as they are displayed
on the Properties tab for future reference.
5.3.3
Enabling Access Point Wireless Communication
Your VCI can be configured for Access Point Wireless
Communication. Before starting, you need to know the
following:
R
An IP Address and Subnet Mask to assign to your
VCI (if your LAN does not automatically assign IP
addresses)
R
Wireless communication access point SSID (network
name)
R
Required network authentication is WPA—Personal,
Open, or Shared
R
Required data encryption is TKIP or WEP (64-bit or
128-bit)
R
Wireless security password (encryption key)
The illustration below shows several VCIs connected to
a single laptop PC using a wireless access point.
Use the following procedure to configure your VCI for
wireless communication in your environment. Before
modifying the VCI communications interface, contact
your IT Administrator.
1.
Start the VCI Manager software by clicking on the
VCI Manager icon.
2.
Plug the USB cable into the PC and VCI.
3.
Power on the VCI by plugging in the AC/DC 12-volt
power supply.
4.
Select and Connect to your VCI in the VCI Manager
software VCI Explorer tab.
Содержание MTS 6520 VCI
Страница 309: ......
