Bosch LTC 1311/20 FlexiDome I, Руководство по настройке

Страница: 21 / 188

Bosch Video Management System Configuring devices | en 21
Bosch Sicherheitssysteme GmbH Configuration Manual Configuration Client | V3 | 2010.07
– Section 17.10 DiBos page, page 92
– Section 17.11 Matrix Switches page, page 93
– Section 17.12 Workstation page, page 95
– Section 17.14 Monitor Groups page, page 97
– Section 17.15 Communication Devices page, page 98
– Section 17.16 POS + ATM page, page 101
– Section 17.17 Virtual Inputs page, page 102
– Section 17.18 SNMP page, page 103
– Section 17.19 CCTV Keyboards page, page 104
– Section 17.20 I/O Modules page, page 105
6.1 Detecting NVRs, their recorded encoders, and decoders
Main window > Devices > NVR & Decoder Scan > Network Scan dialog box
You scan the network to detect the following devices:
– NVR s
– Decoders
– Encoders
The system automatically adds a default analog monitor group with the detected decoders
assigned. This analog monitor group is added below .
When you scan the network for the first time, NVRs and decoders are automatically assigned
to the system.
You must manually assign detected encoders to NVRs.
To avoid conflicts with duplicate IP addresses you start the initial device scan. This is useful
when you integrate new devices in your network which have duplicate IP addresses or the
factory default IP address (192.168.0.1). You cannot perform this initial device scan
successfully with devices that are password protected.
When you want to add devices that are not members of the same subnet, perform the initial
device scan.
To start the initial device scan:
1. On the Hardware menu, click Initial Device Scan... .
The Initial Device Scan dialog box is displayed.
2. Click a cell to change the desired address. For changing multiple devices, select the
desired rows. You can select multiple devices by pressing the CTRL- or the SHIFT-key.
Then right-click the selected rows and click Set IP Addresses... or click Set Subnet
Mask... to change the corresponding values.
You must enter the correct subnet mask before changing an IP address.
3. Click OK .