Bosch ISC-FPB1-W120QS, Инструкция по установке и эксплуатации

Страница: 9 / 28

Installation
Prior to installing the devices, please review the installation considerations below:
–
Install in an area that is clear of objects
– Install the transmitter/receiver within the maximum protection range of the model
– Do not install:
–
Receivers into intense sources of light (for example, rising and setting sun)
– On movable surfaces subject to vibrations
– Detectors where immersion to water, corrosive liquids, or exposure to high levels of
dust can occur
– Detectors in close proximity to strong electromagnetic noises
– Do not use detectors with other photobeam detectors or receivers
– Do not stack detectors
– Do not disassemble or modify this detector
– Do not install while the power is on
– Avoid extreme temperature and humidity ranges as defined in the products specifications
– Avoid installing detectors near magnets and/or magnetized materials
– Avoid beam interference between other units when multiple units are installed.
Beam spread
The beam spread angle is ±0.7 °from the transmitter to the receiver. Refer to the diagram and
table below to determine the installation conditions.
1
5
4
3
2
Figure 3.1: Beam distance and spread
Callout
﹘
Description Callout
﹘
Description
1
ー
Transmitter 4
ー
Receiver
2
ー
Horizontal spread (B) 5
ー
Distance (A)
3
ー
Vertical spread (C)
3
3.1
Photobeam 5000 Installation | en 9
Bosch Security Systems, Inc. Installation and Operation Guide 2016.02 | 03 | F.01U.305.910