Bosch ISC-FPB1-W120QS, Инструкция по установке и эксплуатации

Страница: 20 / 28

Optical alignment
Perform the following to align the detector.
Level LED - alignment of the Upper Beam
Perform the following to align the upper beam.
Aligning of the upper bean:
1.
Turn on the transmitter Function switch 1 (Upper Beam). The monitor LED flashes (5
times/sec).
2. Turn on the receiver Function switch 2 (Level Check) of the receiver.
3. Look into the scope at the center of the lens from a 10-15 cm (4-5 in) distance, adjust the
horizontal direction by rotating the turntable and the horizontal adjustment screw. Adjust
the vertical direction by rotating the vertical adjustment screw. Adjust until you locate the
other part of the sensor in the center of the scope view.
4. Check the level LED of the receiver. Perform fine adjustments and repeat procedure until
LED turns off. Refer to Volt meter alignment, page 21.
1
2
3
4
5
Figure 7.1: Optical alignment
Callout
ー
Description Callout
ー
Description
1
ー
Turntable 4
ー
Scope view finder
2
ー
Verticle adjustment screw 5
ー
On/Off switch
3
ー
Horizontal adjustment screw 6
Notice!
Turn on Function switches 1 and 2 of the transmitter after finishing the alignment to verify the
monitor LEDs light up once every 3 seconds.
Level LED - alignment of the Lower Beam
Perform the following to align the lower beam.
Aligning of the lower beam:
1.
Turn on the transmitter Function switch 2 (Lower Beam).
7
7.1
7.2
20 en | Optical alignment Photobeam 5000
2016.02 | 03 | F.01U.305.910 Installation and Operation Guide Bosch Security Systems, Inc.