Bosch CCS 800 Ultro, Инструкция по установке и эксплуатации

Страница: 20 / 36

Bosch Security Systems B.V. | 2007-08
CCS 800 Ultro | Installation and Operating Manual en | 20
7.3.2 Deleting files
Use this option to delete files.
1 Press the up or down button to select the file to
delete. The filename will change on the display as
the button is pressed.
2 Press the confirm delete button to confirm the file to
delete (the following screen will be displayed).
Figure 7.4: Confirm delete screen
3 On this screen, you can either:
- select the delete file button to permanently delete
a file.
- select the cancel delete button to cancel the delete
file command.
4 Press the select button to select the next value to
change (see following section).
7.3.3 Setting the date and time
Before using the MP3 recorder you should make sure
that the date and time are correctly set. If necessary,
adjust the date and time as follows:
1 Press the change mode button (1) to select the set-up
mode. When selected, the set-up icon should be
shown in the top right-hand corner of the display
(see following figure).
Figure 7.3: Set-up screen for date
2 Press the up or down button (4 or 5) to change the
value (year number), and then press the select button
(2) to select the next value to change.
3 Set the date (year, month, and day) as described in
the previous step, and then press the next button (3)
to jump to the time set-up screen.
4 Set the time (hours, minutes, and seconds), using the
same method as described in step 2, and then press
the next button to jump to the bit rate set-up screen
(see following section).
Note
After deleting a file, the software jumps back to
the delete file screen.
Note
To change settings in the set-up mode, you must
follow the programmed sequence of events
(there is no back button). To exit the set-up mode
at any time, press the change mode button
(button 1 at the left-side of the display).