Bosch BEA 150, Инструкции по ремонту

Страница: 55 / 103

55
8.3 Messages about boot test functions
No. Message Possible cause Remedy Section
1010 Checksum error in flashrom Error in software Re-boot BEA, if error still present:
Re-install system software
5.23
Faulty flashrom Replace control module PCB 10.27
1011 RAM test error Faulty RAM module Re-boot BEA, if error still present:
Replace control module PCB
10.27
1012 Error in data bus dt1
1013 Error in data bus dt2
Error in control module PCB Re-boot BEA, if error still present:
1014 Error in data bus dt3 Replace control module PCB 10.27
1015 Error in data bus dt4
1016 Error in data bus p1
1017 Error in data bus p2
1018 Disk error Disk write-protected Remove write protection
Loose interconnecting cables Check that interconnecting
cables secure, check for
continuity
12.1 and 12.4
Error in voltage supply Check voltage supply 10.2 and 10.3
Faulty disk drive Check disk drive 5.9
1019 Battery undervoltage Battery faulty or discharged Check battery, replace if necessary 10.32
Error in control module PCB Replace control module PCB 10.27
1020 Error in data bus dt5 Error in control module PCB Re-boot BEA, if error still present:
1021 Error in data bus dt6 Re-install system software 10.27
1022 Error in video RAM Faulty video RAM module Perform video RAM test 5.13
Replace control module PCB 10.27
1023 HD error Loose interconnecting cables Check that interconnecting
cables secure, check for
continuity
12.1 and 12.4
Error in voltage supply Check voltage supply 10.2 and 10.4
Faulty hard disk Check hard disk, if error 5.8 and 10.23
still present: replace hard disk
1030 Clock faulty or shows incorrect time Date and time incorrectly set Set date and time correctly, 5.12
if error still present:
replace control module PCB
10.27