Bosch Autodome IP 4000 HD, Руководство по установке

Страница: 22 / 57

22 en | Installing an In-ceiling Camera in a Suspended Ceiling AUTODOME IP 4000 HD
2015.11 | 1.1 | Installation Manual Bosch Security Systems
24V
A
C
RJ
4
5
24V
A
C
Figure 8.5: Connect cables to camera
2. Insert the camera (without the trim ring / bubble enclosure) into the hole in the ceiling.
Ensure not to pinch the cables.
Figure 8.6: Insert camera into hole
3. Turn each fastening screw (item 1 in the following figure) to secure the clamps in the
ceiling.
4. Tighten the clamps using the T10 Torx screwdriver to secure the housing to the ceiling.
!
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
Figure 8.7: Secure clamps to ceiling
5. Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws (item 1 in the following figure). Tighten the screws firmly to secure the
trim ring / bubble enclosure to the in-ceiling bracket.
6. Remove the protective plastic sheet from the bubble. Installation is complete.