Bosch Autodome IP 4000 HD, Руководство по установке

Страница: 20 / 57

20 en | Installing an In-ceiling Camera in a Suspended Ceiling AUTODOME IP 4000 HD
2015.11 | 1.1 | Installation Manual Bosch Security Systems
8 Installing an In-ceiling Camera in a Suspended Ceiling
8.1 Tools Required
– Appropriate straight slot screwdriver
– Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable)
8.2 Installation Requirements
– The ceiling thickness ranges from 10 - 40 mm.
– The ceiling can sustain at least eight (8) times the weight of the camera (1.81 kg (4 lb)): >
14.5 kg (32 lb).
8.3 Prepare Suspension Ceiling for Installation
You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1.
Choose the desired location to mount the camera.
2. Remove an adjacent ceiling tile.
3. Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
4. Place the Bracket Assembly over the ceiling tile, which is used to mount the camera.
5. Snap the Bar Clips of the bracket to the ceiling rails.
A
Figure 8.1: Suspension Ceiling Bracket (Top View)
1 Suspension Bars 3 Securing Screw (4)
2 Base Plate 4 Bar Clips
1. Use the bracket Base Plate as a template or cut a hole-sized hole in the center of the
ceiling tile with a drywall utility saw or jig saw.