Bosch AMAX panel 2000 EN ICP-AMAX-P-EN, Руководство по установке, Страница: 40 / 92

40 en | System Functions AMAX panel 2000 / AMAX panel 2000 EN
F.01U.241.127 | V4 | 2011.12 Installation Manual Bosch Sicherheitssysteme GmbH
A Duress Alarm is useful only if your system reports to a monitoring station, because domestic
reporting format cannot define the type of alarm that occurred.
6.2 Siren Test
This function allows code holders to test Sirens.
Enter your Code + [1] and press [#] two beeps sound and siren's are activated for a 1~2 sec
burst. No other sounding device operates during this mode. This function can only be
operated as:
1. Disarm
2. No siren output is running.
6.3 Fault and Tamper Analysis Mode
This function allows code holders to identify detailed Faults and Tamper conditions.
There are a number of system faults that can be detected by the control panel. When any of
these faults are present, the FAULT indicator flashes and the keypad beeps once per minute.
Refer to Section 5 Fault and Tamper Description, page 29 for more information on each fault
type.
To determine the type of fault:
1. Enter your Code + [2] and press [#] two beeps sound
The STAY, AWAY, and FAULT indicators flash.
One or more zone indicators (1 - 8) light to indicate the type of fault that occurred.
6.4 View date and time
This function allows user code holder to view the date and time
1. Enter your code +[3] and press [#]. Two beeps sound, the STAY and AWAY indicators
flash and date + time is shown in the format YYMMDD HHMM.
2. If operation is not carried out within 240 seconds after entering the date and time setting
interface, the system will automatically exit from the setting.
6.5 Walk Test Mode
This function allows code holders to test detection devices to ensure they are functioning
correctly. Before activating Walk Test Mode, bypass any zones that are not required for
testing.
To enter Walk Test Mode:
1. Enter your Code + [4] and press [#] .
Two beeps sound and the STAY and AWAY indicators flash. The keypad beeps once per
sec when Walk Test Mode is active.
2. Unseal and seal the zones to be tested.
The keypad sounds one second beep and the siren sounds one beep each time when a
zone status is changed.
3. Press [#] to exit from this function.
Two beeps sound and the STAY and AWAY indicators are extinguished. The system
returns to the disarmed state.
NOTICE!
It only can be operated in Disarm Mode.