Page 3
I. Safety requirements and precautions
• Device should be powered from the mains with an alternating current of 220 - 240V.
• Internal installation must have a 16A fuse.
• Device must be unconditionally connected to the socket outlet with earthing contact.
• If the power cord or plug is damaged, to avoid danger, it should be replaced at the
manufacturer, or by a specialised repair shop, or by a qualified electrician.
• Before starting cleaning the device, disconnect the power supply.
• Smoke generator can only be connected to the power supply after it has been installed in
the device adapted to its assembly.
• If you use an electric extension cord, its current load should be at least as much as the rated
load of the device.
• If you use an electric extension cord, make sure it has an efficient earthing contact (ground).
• Lay the power cords in such a way that they are not crushed, prevent it against pulling or
stumbling over by children.
• If you use electric extension cords, they must be adapted for outdoor use and should be
labelled "for outdoor use".
• Power cords of the device should be arranged in such a way that they are not in contact with
hot parts of the housing.
• The smoker is intended for outdoor use but it must not be exposed to atmospheric
precipitation and strong gusts of wind. The optimal solution is to work in roofed, sheltered
and, at the same time, ventilated places.
• Do not use the device in closed rooms, in case of use under a roof ensure sufficient
ventilation.
• Do not use the device near gasoline or other flammable liquids, gases or places where
flammable vapours may be present.
• Do not use the device near flammable objects.
• Do not use the device when it comes in contact with parts, objects made of materials not
resistant to high temperature.
• It is recommended to put an extinguisher near the device. Information on the proper size
and type of the extinguisher can be obtained from the local authorities.
• Do not connect the device until it has been fully assembled.
• Do not move the device before removing all moving objects inside the smoker and the
smoke generator.
• Do not connect the device to the chimney, ventilation grille or other wires that may cause
forced air draft.
NOTE - LOCATION
NOTE - ELECTRICITY
