Page 14
Embed electronic panel on the left side of the
smoker having regard to protruding screws
from the wall - they should enter into the
corresponding holes (point. A) of the panel.
Move the electronic panel to the left so that the
connectors on the panel and the smoker are
joined.
Finally, tighten the holding and locking screws
in the appropriate places (point B).
RIGHT
A
B
VIII. First start
Fill the bowls halfway with water and place them under the generator burner - under the
drip tray openings. Fill the generator hopper with the supplied chips and slightly open the air
damper at the top of the smoker. The bowls should be cleaned and filled with fresh water every
2 - 4 hours.
Connect the generator and the smoker to 230V mains with protective grounding. Switch to
start the smoke generator and the smoking unit, on the electronic panel set the temperature
to approx. 80°C (see: Operation of the electronic control panel)
Heat the smoker for about 2 hours. This will reduce technological odours and ensure initial
flavouring of the device. After heating, you can start the proper smoking.
NOTE: Fill the storage tank of the smoke generator only with wood chips indicated by the
device manufacturer.
Warm smoking (30°C - 60°C) - With only the smoke generator on, we can conduct warm
smoking. In unfavorable atmospheric conditions, we can turn on the smoking unit by setting
the right temperature on the temperature controller.
Hot smoking (60°C - 90°C) - Turn on the generator and the smoking unit, and set the
electronic panel to the desired temperature.
