bora PL540E, Инструкции по эксплуатации и монтажу

Страница: 29 / 36

EN
29
Cleaning and Maintenance
www.bora.com
8.3 Cleaning the control knobs
X X
Make sure that the cooktop extractor is switched off
(see the Operation section).
INFO Only clean the control knob manually.
X X
Pull off the control knob.
X X
Clean the control knob with a soft brush.
X X
Rinse the control knob well after cleaning.
X X
Allow the control knob to dry thoroughly.
X X
Push the control knob onto the control box axle.
8.4 Replacing the activated charcoal
filter
In recirculation mode, an additional activated charcoal
filter is used. The activated charcoal filter absorbs cooking
odours. The activated charcoal filter is installed on the
plinth fan or the duct system.
INFO Regularly replace the activated charcoal filter.
The service life can be found in the operating
instructions for the relevant activated charcoal
filter.
INFO You can obtain activated charcoal filters from
your specialist supplier or by contacting BORA
via the website at www.bora.com.
Q Q
A description of how to replace the activated charcoal
filter can be found in its operating instructions.
X X
Reset the filter service display
(see the Device description section).
Abb. 8.5 Inserting the rotating mechanism
X X
Insert the rotating mechanism by turning it 90°
anti-clockwise at the level of the cooktop extractor.
X X
Push the rotating mechanism into the intended
position.
1
Abb. 8.6 Inserting the cover flap
[1] Cover flap
[2] Tappet
[3]
Control wheel
X X
Turn the control wheel [3] to the middle position.
X X
Insert the cover flap [1].
INFO When fitting the cover flap, ensure that it is at
an angle of approximately 45° so that the tap-
pet glides cleanly into the rotating mechanism.