bora PL540E, Инструкции по эксплуатации и монтажу

Страница: 12 / 36

EN
12
Device description
www.bora.com
5.1 Structure
7
6
5
4
3
2
1
Abb. 5.1 Cooktop extractor
[1]
Stainless steel grease filter
[2]
Cover flap
[3]
Cooktop extractor
[4] Control knob
[5] Power level sleeve
[6] Rotating mechanism
[7] Universal control unit
5.2 Operating panel and operating
principle
1 2
3
Abb. 5.2 Control knob
[1] Control knob
[2] Power level sleeve
[3] Indicator light
5 Device description
Observe all safety and warning information during operation
(see the Safety section).
The cooktop extractor has the following features:
Q Q
Power control via a control knob
Q Q
Freely adjustable power control
Q Q
Cover flap sensor
Q Q
Automatic after-run
Q Q
Filter service display
Q Q
Interface communication
Q Q
Safety shut-down
Depending on the model you purchased, the cooktop
extractor can be operated as an exhaust air or an recircu-
lating air version.
Exhaust mode
The air extracted from the cooktop is cleaned by the
stainless steel grease filter and released outside through
a duct system.
The exhaust air must not be expelled into:
Q Q
a smoke or exhaust gas flue that is in operation
Q Q
a shaft used for the aeration of rooms where
fireplaces are installed.
If the exhaust air is to be directed into a smoke or exhaust
gas flue that is not in use, the installation must be checked
and approved by the responsible heating engineer.
Recirculation mode
The air suctioned away by the cooktop is purified by the
grease filter and an activated charcoal filter and fed back
into the room in which the appliance is installed.
To prevent odours in recirculation mode, an activated
charcoal filter must be used. For hygiene and health
reasons, the activated charcoal filter must be replaced at
the recommended intervals (see the Cleaning and mainte-
nance section).
INFO In recirculation mode, ensure sufficient
ventilation and aeration to expel humidity.