TO EXTINGUISH
1. Push and turn burner control knob clockwise to the "PILOT" position. (Normally,
burner will make a slight popping sound when extinguished). Main burner will
extinguish but Pilot flame will remain ON.
2. To extinguish Pilot flame, depress Control Knob and continue to turn it clockwise to
OFF.
3. Close the LP tank valve.
4. Disconnect the regulator from the LP tank to close the gas supply when not in use.
5. Make sure that the unit is completely cooled before touching any of the components or
putting on the cover.
ROUTINE CARE
Keep your appliance free and clear from combustible materials.
Visually inspect burner for obstructions, keep tank enclosure free and clear from
debris.
After the burner and lava rocks are completely cooled down, use a soft brush to get rid
of the mild stains, loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
Stubborn stains, discoloration and possibly rust pitting can occur from exposure to
harsh outdoor conditions.
Be careful not let any powder or solvent come in contact with painted or plastic
components as damage may occur.
MAINTENANCE
Store the appliance in a cool dry place away from direct sunlight.
Make sure both the gas and the appliance are turned off before changing battery.
Please refer to the process of inserting battery.
Protect your appliance with the cover when not in use.
The propane cylinder must be disconnected and stored outdoors before the
appliance can be stored indoors.
Use Manufacturer approved or supplied replacement parts and accessories only.
Otherwise may void the warranty of this product and result in a hazardous condition.
Please contact the Manufacturer for information regarding replacement hoses,
thermocouples, igniters, lava rocks, etc.
PROBLEM
CAUSE
CORRECTIVE ACTION
Pilot will not light
Igniter pin and burner are wet
Wipe dry with a cloth
Igniter battery is incorrectly
inserted.
Check that battery is correctly inserted.
Igniter pin cracked or broken
Call customer service for replacement part
Electrode wire is loose or
disconnected
Reconnect wire to the igniter
box located inside the table
base behind the igniter button
.
Electrode wire is shorting
between valve and igniter pin
Call customer service for replacement part
12
TROUBLESHOOTING
