- 13 -
5-E Power Cord / Power Connection
Always make sure that the power switch is set to the OFF position before performing the
following tasks:
o
Plugging and unplugging the AC cord into the back of the unit.
o
Plugging and unplugging the 3-prong plug into a grounded electrical outlet.
Safety Instructions
A. Grounding:
Verify that the main unit is connected to a grounded outlet prior to connecting other parts to
the main unit.
B. Main voltage range and fuse:
Check the voltage of the ART-SP2 for compatibility with your local voltage before plugging
the power cord into the outlet.
5-F Foot Control Cable Assembly Connection
Align the pins of the foot control plug with the receptacle on the back of the device and push firmly
until seated.
5-G Water Supply Line Connection
Push the blue water tube (hose) over the stainless steel receptacle on the back of the unit. Then
tighten the screw over it.
Connect the quick connector to the water supply line. The ART-SP2 standard package comes with a
male quick connector. If a female quick connector is necessary, please contact a Bonart authorized
dealer to purchase it.
Inspect all connections for leaks.
To remove the water line from the ART-SP2 scaler, turn off the water supply or disconnect the water
supply line from the water tube. Then loosen the screw on the water tube from the receptacle of
the unit and gently pull the water tube off.
5-H Hand piece Cable Assembly Connection
The hand piece is the housing for the piezo tips. It is the part that you hold during operation. The
hand piece must be attached to the hand piece cable prior to using. To attach, connect the free end
of the cable to the matching receptacle on the back end of the hand piece. Do not twist or turn.
