Starting
Don’t forget the earth circuit
Starting position.
breaker.
Wheel adjustment
Changing sanding material
Changing sanding material must be made on an unconnected machine.
Never start the machine before a sanding disc is attached.
OK
The distance between the under-
side of the motor bracket and the
floor should be approx. 75 mm for
standard arm and approx. 80 mm
for long arm. Use box wrench NV24
for adjusting to the correct sanding
picture, see next picture.
Dust collection
For minimal dust discharge Bona
’s original dust bags shall al-
ways be used. The dust bag must
be emptied when it is filled to max
1/3.
Lay the edge sander carefully on
its left side. Regularly check the
sanding disc. If the sanding disc is
worn out or has become clogged
by lacquer or paint, the sanding
result deteriorates and the surface
of wood may become discolored.
Always use Bona’s sanding discs
of the correct size and stable rear
side. Only abrasive paper suita-
ble for sanding of wooden floors
should be used.
Check that the sanding disc is
centered.
Changing sanding disc with hole
Removing sanding disc with hole.
Use box spanner NV17.
Changing velcro disc
If the velcro disc is worn, scrape
the disc off with a knife.
Clean the steel disc with meths
or similar.
Glue a new Velcro disc on the
steel plate.
Check that the disc is positioned. A
disc that is not centered may cause
unbalances and vibrations.
When emptying the dust bag,
remove the dust tube, together
with the dust bag, completely,
open the zipper and empty the
contents.
If the whole disc is flat and in full
contact with the floor it will create
excessive resistance in the motor,
leave circular scratch marks, and
the machine will be hard to
handle.
The angle of the handles can
be adjusted for a more
comfortable working
position. Use Torx wrench
T30.
E
n
g
lis
h
E
n
g
lis
h
