Bomar Individual 620.460 GANC, Руководство по эксплуатации

Страница: 48 / 135

48
Manual version: 1.10 / Jan. 2011
Manual rev.: 1
Ovládá
ní str
o
je
Bedi
en
ung
der
Masch
ine
Machine control
5. Release the tightening bolt of the brush (see arrow) so the brush can be moved.
6. Set the brush to the saw band. Ends of the brush bristles should not touch the saw
band teeth.
7. Tighten the bolt.
8. If the brush is not rotating properly (brush drive wheel slips on the saw band drive
wheel) press down the wheel using the bolt to the saw band drive wheel.
3.7.12. Material insertion
•
Never walk under a suspended load!
•
Never climb onto the gravity-roller conveyor!
•
Do not hold the material for clamping material to the vice! The vice can cause
injury!
3.7.13. Handling agent selection
•
Use the strong handling agents to lift and transfer the material!
•
Handle with the material only with the lift truck or use the suspension strands and
the crane!
•
Do not use the lift truck or crane in case that you do not have the license to handle
with it!
3.7.14. Insertion
Insert material to the vice and ensure that the material cannot move in the vice or fall
from the vice after the clamping. If you cut long pieces of the material (for example rod,
tube), you must use the roller conveyors for material shifting to the band saw. Contact
Bomar for more information about roller conveyors
Make sure the conveyor is long enough and the material cannot tip off the conveyor.
Be especially careful with round materials that it always stays on two vertical
rollers and that it cannot fall off the conveyor!
3.7.15. Bundle material cutting
If you want to cut the material in the bundle, there are suggestions for the positioning
of bundles
Round material bundle: Take care especially with round material that the bars are put
according to the picture. If the bars are put differently, you may have problems with
movement.
Always weld the material at the rear end of the bundle to secure it from moving.
Before welding always, switch the machine off at the main switch! The magnetic fields,
which often occur during welding, may damage the controls!
Square material bundle:
Attention:
Not all material shapes are suitable for bundle cuts. Keep the
recommendation of your supplier of the saw bands for material
insertion to the bundle.